top of page
This project required taking scans from a two piece gas tank and designing a one piece tank that replicated the exterior and captured all the interior mounting holes and mating geometry. (The original tank was for gasoline and the new version was going to be converted to electric).
The scans were aligned and preliminarily modeled in Geomagic Design X, and then fully transferred to Solidworks to finalize the details. The result is a full, parametric and history based model that matches the original scans. (Deviation analysis of finished model to original scans done in Geomagic).

Original 2 piece tank on bike

original 2 piece tank

Deviation analysis of finished design to original scans.

Original 2 piece tank on bike
1/15
bottom of page